騰達試驗儀器廠；

　　瀝青三氯乙烯回收儀是**瀝青檢測儀器，用于回收受污染的可燃溶性劑，可與離心式瀝青混合料分離器配套使用，做為三氯乙烯或笨的回收裝置。本儀器具有布局合理、結構緊湊，重量輕、整體性強、外形美觀，操作簡單，自動化程度高等特點?？蛇m用于教學，科研及道路工程施工監理等部門。

　　Asphalt trichloroethylene recovery instrument is a professional asphalt detection instrument for recovering contaminated flammable solvents.It can be used with centrifugal asphalt mixture separator as a trichloroethylene or stupid recovery device.This instrument has the characteristics of reasonable layout,compact structure,light weight,strong integrity,beautiful appearance,simple operation and high degree of automation.Can be applied to teaching,scientific research and road engineering construction supervision departments.

　　瀝青三氯乙烯回收儀技術參數：

　　★溫度控制范圍:50~200℃

　　★電源電壓:220 V

　　★功率:1000W×2

　　★回收能力:10L/h

　　★整機重量:18Kg

　　★外形尺寸:610×460×550（長×寬×高）

　　Technical parameters of HHS-1 asphalt trichloroethylene recovery instrument

　　★Temperature control range:50~200℃

　　Power supply voltage:220 V

　　Power:1000W×2

　　Recycling capacity:10L/h

　　Machine weight:18Kg

　　★Dimensions:610×460×550(length×width×height)

　　瀝青三氯乙烯回收儀操作規程：

　　★接通電源并把進出水與蒸餾器用軟管固定連接好。

　　★把需回收的溶液倒入蒸餾室，一次倒入A大容量約為10升。

　　★通過冷卻水，閉合電源總開關，紅色電源指示燈亮，按下加熱按鈕，加熱指示燈亮，儀器開始工作，進入加熱狀態。

　　★當儀器在蒸餾完成以后，此時應及時切斷總電源。

　　★操作者通過液位計觀察玻璃管中的液面，若看到瀝青液面，應打開右側水咀截門，將瀝青液體放完。當左側液位計的液面達到上限位置時，應及時打開水咀放出回收的溶液。

　　★溫控器中的溫度開關，可按不同溶劑的不同沸點而加以調定，本儀器的控制溫度出廠時已按三氯乙稀的溫度調整好（86°），不要隨意改動，如做其它瀝青溶劑時，應予先掌握并調整好沸點溫度。

　　HHS-1 asphalt trichloroethylene recovery instrument operating procedures:

　　★Turn on the power and connect the inlet and outlet water to the still with a hose.

　　★Put the solution to be recovered into the distillation chamber,ａnd pour A into a large volume of about 10 liters at a time.

　　★With cooling water,close the main power switch,the red power indicator light is on,press the heating button,the heating indicator light is on,the instrument starts to work,ａnd enters the heating state.

　　★When the instrument is completed with distillation,the main power should be cut off in time at this time.

　　★The operator observes the liquid level in the glass tube through the liquid level gauge.If the liquid level of the asphalt is seen,the right side water nozzle should be opened to stop the asphalt liquid.When the liquid level of the left level gauge reaches the upper limit position,the water nozzle should be opened in time to discharge the recovered solution.

　　★The temperature switch in the thermostat can be adjusted according to the different boiling points of different solvents.The control temperature of this instrument has been adjusted according to the temperature of trichloroethylene(86°)when leaving the factory.Do not change it at will,such as doing other When bitumen solvents are used,the boiling point temperature should be mastered and adjusted.

　　HHS-1瀝青三氯乙烯回收儀工作原理：

　　當電加熱通電后，電能通過電阻絲轉變成熱能，使置于溶器中的三氯乙稀瀝青溶液升溫。當溶液的溫度達到三氯乙稀溶劑的沸點時（86.7℃）三氯乙稀通過分子運動將液體轉變成氣體蒸發出來，此時瀝青油及其它雜質由于沸點高，仍滯留在溶液中，蒸發過程是一個加熱過程，盡管電加熱器仍在工作，溶液的溫度也不會升高，當溶液中的三氯乙稀全部被蒸發掉時，剩下的瀝青液的溫度才會升高，此時電源通過溫度控制開關自動切斷，加熱器停止工作，瀝青液滯留在容器右腔，三氯乙稀氣體通過容器上部的空間進入左腔，左腔的冷卻循環水使三氯乙稀蒸氣分子遇冷，溫度下降，重新變成液體留在左腔，這樣**完成了三氯乙稀的回收工作。

　　HHS-1 asphalt trichloroethylene recovery instrument works:

　　When the electric heating is energized,the electric energy is converted into heat energy through the resistance wire,so that the trichloroethylene pitch solution placed in the dissolver is heated.When the temperature of the solution reaches the boiling point of trichloroethylene solvent(86.7°C),trichloroethylene will evaporate the liquid into gas through molecular movement.At this time,the bitumen oil and other impurities will remain in the solution and evaporate due to the high boiling point.The process is a heating process.Although the electric heater is still working,the temperature of the solution will not rise.When all the trichloroethylene in the solution is evaporated,the temperature of the remaining asphalt liquid will rise.At that time,the power is automatically cut off by the temperature control switch,the heater stops working,the asphalt liquid is trapped in the right cavity of the container,ａnd the trichloroethylene gas enters the left cavity through the space in the upper part of the container.It is cold,the temperature drops,ａnd it becomes a liquid again and stays in the left cavity,so that the recovery of trichloroethylene is completed.

　　HHS-1瀝青三氯乙烯回收儀儀器結構：

　　容器全部由不銹鋼制成，分為兩室，蒸餾室位于右側，儲存室（包括冷凝器）位于左側。蒸餾室的容積約為10升，儲存室的容積為6升，容器下部各有一水咀，右側為放出瀝青溶液的水咀，左側為放出已回收溶劑的水咀，蒸餾室下部設有二組電阻絲式加熱器。

　　冷凝器位于左側儲存室的上部。由8層盤管組成，直接與自來水連接進行冷卻，上蓋用耐腐蝕膠圈密封，防止三氯乙稀的蒸發氣體跑出，污染工作環境，溫控器位于電器盒內，溫控器觸頭與加熱介質接觸，到設定溫度時立即斷電，整個過程自動完成。

　　在殼體的前面裝有兩支液位計，右側的液位計主要用來檢查倒入待回收的液體，蒸餾完畢，如液位計仍能看到殘留余液的液面，**在打開右側水咀把殘留的液體放出，如左側的液位計上的液面達到了上限的位置**要打開左側水咀，放出已清潔的三氯乙稀液體。

　　漏斗中設有一個篩網，防止顆粒狀物體進入蒸餾室。漏斗咀中部設有一個防濺網，防止在倒入污染的液體時濺入右側。電器盒下部設有絕緣蓋板防止人員觸電。

　　HHS-1 asphalt trichloroethylene recovery instrument structure:

　　The vessel is made entirely of stainless steel and is divided into two chambers,with a distillation chamber on the right and a storage chamber(including the condenser)on the left.The volume of the distillation chamber is about 10 liters,ａnd the volume of the storage chamber is 6 liters.There is a water nozzle at the bottom of the container,a water nozzle that discharges the asphalt solution on the right side,ａnd a water nozzle that releases the recovered solvent on the left side.Two sets of resistance wire heaters.

　　The condenser is located in the upper part of the left storage compartment.It consists of 8 layers of coils.It is directly connected to the tap water for cooling.The upper cover is sealed with a corrosion-resistant rubber ring to prevent the trichloroethylene evaporated gas from running out and pollute the working environment.The thermostat is located in the electrical box.The head is in contact with the heating medium,ａnd the power is immediately turned off when the set temperature is reached,ａnd the entire process is automatically completed.

　　There are two level gauges on the front of the casing.The level gauge on the right is mainly used to check the liquid to be recovered.After the distillation is completed,if the level gauge can still see the remaining liquid level,**Open the water nozzle on the right side to discharge the remaining liquid,such as the position where the liquid level on the left-side level gauge reaches the upper limit.

　　A sieve is installed in the funnel to prevent granular objects from entering the distillation chamber.A splash screen is provided in the middle of the funnel to prevent splashing to the right when contaminated liquid is poured.The lower part of the electrical box is provided with an insulating cover to prevent electric shock.

　　HHS-1瀝青三氯乙烯回收儀注意事項：

　　1、要隨時抽查被蒸餾溶劑的PH值，（氯化的碳?xì)浠衔铮?。如PH值低于5時，回收器的整個內部要被損壞，在這種情況下，要及時清洗蒸餾室。

　　2、儀器使用時外皮接地。

　　3、儀器工作時，不要離人。

　　4、清理儀器時，應拔掉電源插頭，并防止水浸入電器元件。

　　HHS-1 Asphalt Trichloroethylene Recovery Instrument

　　1.Always check the pH of the solvent being distilled,(chlorinated hydrocarbons).If the pH value is below 5,the entire interior of the recoverer will be damaged.In this case,the distillation chamber should be cleaned in time.

　　2.The skin of the instrument is grounded during use.

　　3.When the instrument is working,do not leave the person.

　　4.When cleaning the instrument,unplug the power plug and prevent water from entering the electrical components.