產品簡介
德國P+F倍加福NBB15-U1-Z2接近開關原廠現貨供應
在有些應用場合，對傳感器的堅固耐用程度有著很高的要求，那么此類螺紋式堅固型不銹鋼感應面?zhèn)鞲衅髡菨M足這種應用的選擇。類似于機械工具制造或金屬加工等應用場合，常常會使傳感器受到碰撞、磨損和被腐蝕性溶劑或其他流體侵蝕，那么在此環境下，不銹鋼感應面?zhèn)鞲衅骶湍馨l(fā)揮出它的巨大優勢：大大減少停工時間，延長使用壽命，有效提高生產效率。
產品介紹
德國P+F倍加福NBB15-U1-Z2接近開關原廠現貨供應
在有些應用場合，對傳感器的堅固耐用程度有著很高的要求，那么此類螺紋式堅固型不銹鋼感應面?zhèn)鞲衅?/strong>正是滿足這種應用的選擇。類似于機械工具制造或金屬加工等應用場合，常常會使傳感器受到碰撞、磨損和被腐蝕性溶劑或其他流體侵蝕，那么在此環境下，不銹鋼感應面?zhèn)鞲衅?/strong>就能發揮出它的巨大優勢：大大減少停工時間，延長使用壽命，有效提高生產效率。
德國P+F倍加福NBB15-U1-Z2接近開關原廠現貨供應
電感式模擬量輸出傳感器用于在特定感應距離內檢測金屬目標物位置。檢測到的目標物位置對應輸出一個與檢測距離成比例的模擬量信號，從而使此款傳感器成為測量控制的理想之選。倍加福產品能提供的檢測范圍有2…5mm,3…8mm和15…40mm。由于電感式模擬量傳感器的溫度漂移低，每攝氏度溫漂只有1/1000的偏差，在非常態的情況下依然能保證其可靠性和高精度。
| General specifications |
|---|
| Switching function | Normally open/closed (NO/NC) | | Output type | Two-wire | | Rated operating distance | 15 mm | | Installation | flush | | Output polarity | DC | | Assured operating distance | 0 ... 12.15 mm | | Actual operating distance | 13.5 ... 16.5 mm typ. 15 mm | | Reduction factor rAl | 0.3 | | Reduction factor rCu | 0.3 | | Reduction factor r304 | 0.7 | | Nominal ratings |
|---|
| Operating voltage | 5 ... 60 V | | Switching frequency | 0 ... 400 Hz | | Hysteresis | typ. 5 % | | Reverse polarity protection | reverse polarity tolerant | | Short-circuit protection | yes | | Voltage drop | ≤ 5 V | | Voltage drop at IL | | | | Voltage drop IL = 100 mA, switching element on | ... 5 V | | Operating current | 2 ... 200 mA | | Off-state current | 0 ... 0.5 mA | | Switching state indicator | 2 LED, yellow | | Functional safety related parameters |
|---|
| MTTFd | 1133 a | | Mission Time (TM) | 20 a | | Diagnostic Coverage (DC) | 0 % | | Approvals and certificates |
|---|
| EAC conformity | TR CU 020/2011 | | UL approval | cULus Listed, General Purpose | | CSA approval | cCSAus Listed, General Purpose | | CCC approval | Certified by China Compulsory Certification (CCC) | | Ambient conditions |
|---|
| Ambient temperature | -25 ... 85 °C (-13 ... 185 °F) | | Mechanical specifications |
|---|
| Connection type | screw terminals | | Information for connection | A maximum of two conductors with the same core cross section may be mounted on one terminal connection!
tightening torque 1.2 Nm + 10 % | | Core cross-section | up to 2.5 mm2 | | | Minimum core cross-section | without wire end ferrule 0.5 mm2 , with connector sleeves 0.34 mm2 | | | Maximum core cross-section | without wire end ferrule 2.5 mm2 , with connector sleeves 1.5 mm2 | | Housing material | PA/metal with epoxy powder coating | | Sensing face | PA | | Degree of protection | IP68 / IP69K | | Mass | 225 g | | Note | Tightening torque: 1.8 Nm (housing) |
|
|---|
免費會員
具體成交價以合同協議為準
