Specification & Features
􀂙 Input Signal : 0.5 ~ 3.5mV/V DC 􀂙 Auto Calibration
􀂙 Display Speed control : 20 Steps Max. 􀂙 Data Protection
􀂙 Auto Zero, Peak, Hold 􀂙 Full 5 Digit LED Display
􀂙 Relay Output : 2(8) Channel NO / NC (Hysteresis & Range Function)
􀂙 Analog Output : DC 0 ~±10V, 0(4) ~ 20mA

Program [PRG] : Switch to select one of the modes cycles
2) [▲] : Press to change data (0, 1, 2, 3 ...)
3) [▶] : Press to select data position
4) Enter [ENT] : Press to confirm data
5) Zero [Z] : Turn to adjust analog output zero
6) Span [S] : Turn to adjust output span
7) CAL : Input mode indicates Calibration mode.
8) SCALE : Input mode indicates Scale mode.
9) [RY1] : Relay number 1 on/ off indicating light
10) [RY2] : Relay number 2 on/off indicating light
11) [RY1H] : Input Mode indicates data entry for high limit at Relay 1 mode,
Range Mode indicates input greater than high limit into Relay number 1.
12) [RY1L] : Input Mode indicates data entry for low limit at Relay 1 mode, Range
Mode indicates input less than low limit into Relay number 1.
13) [RY2H] : Input Mode indicates data entry for high limit at Relay 2 mode,
Range Mode indicates input greater than high limit into Relay number 2.
14) [RY2L] : Input Mode indicates data entry for low limit at Relay 2 mode, Range
Mode indicates input less than low limit into Relay number2.
15) [Peak] : Peak function on/off indicating light
3. Special Functions & Connection Diagram
1) Auto Zero Function : Press and hold [ENT], then press [▲] to zero display
2) Peak Function : Press [▲] to enable, press [▶] to disable.
3) Key Lock : Press and hold [ENT], then press [▶] for 2.5 seconds to enable,