FOR VALVE CONTROLLER POTENTIOMETER(GPM-010P) | | | “ GPM “ Potentiometer for Valve Actuator Controller is intended to use remote setting control for one or several units connecting with Valve Controller by manual way in Air handling facilities system. If User set Setting Knob at desired setting location, it can be controlled by combination with Damper Actuator or Valve Actuator. | | TYPE | : for Panel (GPM-010P), for Room(GPM-010R) | | SUPPLY VOLTAGE | : AC24V±10% | | FREQUENCY | : 60Hz | | POWER CONSUMPTION | : 1VA | | OUTPUT SIGNAL | : 0 ~ 10 VDC (factory setting) | | SETTING RANGE | : 0 ~ 99% | | CONNECTING NUMBER OF ACTUATOR | : 6EA (for max. 6 Actuators) | | PANEL CUTTING | : Hole 9Ø | | AMBIENT TEMPERATURE | : 1) On Operation : -10 ~ +50℃ | | PROTECTION CLASS ENCLOSURE | : IP30 | | WEIGHT | : 0.07 Kg | | | | In case of installing on Panel, make the hole for 9 mm (diameter) first. Unscrew the nut of potentiometer axis, fix axis to the hole from inside to outside of Panel. Attach Setting Knob to axis on 0 (zero) point setting. Power source is AC 24V. In case of using several actuators combination, it's preferable to decide capacity of transformer after collecting each Actuator's power consumption | FOR DAMPER CONTROLLER POTENTIOMETER(GPM-010P/R) | | | “ GPM ” Potentiometer for Damper Actuator Controller is intended to use remote setting control for one or several units connecting with Damper Controller by manual way in Air handling facilities system. If User set Setting Knob at desired setting location, it can be controlled by combination with Damper Actuator or Valve Actuator.
| | TYPE | : for Panel (GPM-010P), for Room(GPM-010R) | | SUPPLY VOLTAGE | : AC24V±10% | | FREQUENCY | : 60Hz | | POWER CONSUMPTION | : 1VA | | OUTPUT SIGNAL | : 0 ~ 10 VDC (factory setting) | | SETTING RANGE | : 0 ~ 99% | | CONNECTING NUMBER OF ACTUATOR | : 6EA (for max. 6 Actuators) | | PANEL CUTTING SIZE | : Hole 9Ø | | AMBIENT TEMPERATURE | : 1) On Operation : -10 ~ +50℃ | | PROTECTION CLASS ENCLOSURE | : IP30 | | WEIGHT | : 0.07 Kg | |
| | In case of installing on Panel, make the hole for 9 mm (diameter) first. Unscrew the nut of potentiometer axis, fix axis to the hole from inside to outside of Panel. Attach Setting Knob to axis on 0 (zero) point setting. Power source is AC 24V. In case of using several actuators combination, it's preferable to decide capacity of transformer after collecting each Actuator's power consumption.
| | | |