SD-18MSK直流兩線電感式接近傳感器SANIL韓國(guó)山一Tubular Inductive Proximity Switch > DC2-Wire > SD-18MSK | Product Name | SD-18MSK | Summary | | | Please click on the button on left if you wish to inquire regarding several items. | | | | Outer shape | Model | Sensing distance(m/m) | Output | Response frequency | Power source | 18Ø | | SD-18MSK | 5 | NO | 350㎐ | DC 10~30V |
Model | SD-18MSK | Shape | Shield | Setting distance(Rated) | 5㎜±10% | Setting distence(Actual) | 0~3.5㎜ | Standard target | Iron 18×18×t1㎜ | Hysteresis | Less than 10% of the rated sensing distance | Power source | 12~24V DC±10% (10~30V DC Ripple p-p Less than 10%) | Current consumption | Less than 1.2㎃ | Output | Load current | 100㎃ | Residual voltage | Less than 4.6V(24V DC in power ON state at 100㎃) | Protection circuit | Surge protection circuit, Overload & short circuit protection | Max. response frequency | 350Hz | Environmental Resistance | Ambient temperature | -25 to +70℃, storage:-25~*80℃(Non-freezing condition) | Protection | IP67(IEC Specification) | Cable | *Oil,heat and cold resistant cable *Cable type:cable with 2m *Connector type:cable SD-2I5, SD-2L5 | Accessories | Nut:2pc Washer:2pc | Model | Shield type | SD-18MSK | |
If detecting target with a smaller size than the standard target, the sensing distance will become shorter. ▶Sensors Embebed in Metal | If the sensor is completely embeded in metal, its sensing distance may decrease thus it shall be established with the following values as shown at Table1. | | | Non-Shield | Shield | S□□-12M□ (8M) | S□□-18M□ | S□□-30M□ | S□□-12MS□ (8MS) | S□□-18MS□ | S□□-30MS□ | C | 15(8) | 22 | 30 | 0 | 0 | 0 | D | 36(24) | 54 | 90 | 12(8) | 18 | 30 | E | 20(6) | 40 | 70 | 8(4.5) | 20 | 40 | F | 40(24) | 70 | 90 | 18(12) | 27 | 45 |
When mounting plural proximity switches in parallel or face to face, allow the clearance listed in the table2. below to avoid mutual interference. | | | Non-Shield | Shield | S□□-12M□ (8M) | S□□-18M□ | S□□-30M□ | S□□-12MS□ (8MS) | S□□-18MS□ | S□□-30MS□ | A | 24(16) | 48 | 90 | 12(9) | 30 | 60 | B | 36(24) | 54 | 90 | 24(16) | 36 | 60 |
▶Sensing distance, Correction coefficient | The sensing distance listed in this specifications is for the standard target. For non-ferrous object detection, the sensing distance will be obtained by multiplying the correction coefficient. | Target | Iron | SUS 304 | Brass | Aluminum | All models | 1.0 | Approx. 0.7 | Approx. 0.4 | Approx. 0.35 | | | |