One CAN bus communication port Compatible with CAN specification 2.0 parts A and B On-board optical isolation protection Programmable transfer rate up to 1 Mbps 2500 Vrms photo couple isolation on the CAN bus Jumper select 120Ω terminator resistor for each port Direct memory mapping to the CAN controllers 33MHz 32bit 5V PCI bus (V2.1) plug and play Universal PCI card, supports both 5V and 3.3V PCI bus |
Bus Interface | ||
Type | Universal PCI, 3.3 V and 5 V, 33 MHz, 32-bit, plug and play | |
CAN Interface | ||
Controller | NXP SJA1000T with 16 MHz clock | |
Transceiver | NXP 82C250 | |
Channel number | 1 | |
Connector | 9-pin male D-Sub | 5-pin screwed terminal block |
Baud Rate (bps) | 10 k, 20 k, 50 k, 125 k, 250 k, 500 k, 800 k, 1 M (allow user-defined baud rate) | |
Terminator Resistor | Jumper for 120 Ω terminator resistor | |
Power | ||
Power Consumption | 225 mA @ 5 V | |
Software | ||
Driver | Windows 2K/XP/7, Linux 2.6.37, LabView, DASYLab | |
Library | VB 6.0, VC++ 6.0, BCB 6.0, Delphi 4.0, C#.Net, VB.Net | |
Mechanism | ||
Dimensions | 126mm x 22mm x 85mm (W x L x H) | |
Environment | ||
Operating Temp. | 0 ~ 60 ℃ | |
Storage Temp. | -20 ~ 70 ℃ | |
Humidity | 5 ~ 85% RH, non-condensing |
PISO-CAN100U-T CR | 1-Port Isolated Protection Universal PCI CAN Communication Board with 5-pin Screw Terminal Connector (RoHS) |
CNT-CAN | CAN bus Connector |
CA-0910-C | 9-pin Female D-sub & 3-wire CAN bus cable (1M) |
SG-770 | 7/14 channel Surge Protector |