DARK/OPAQUE SAMPLES: The use of special infrared detector gives the instrument it’s ability to see through dark/opaque samples such as residual fuels with up to 8.0 on the ASTM Color Scale. 測試范圍廣：的紅外線光電檢測，無論是透明或是不透明試樣（ASTM色小于8.0）,都可測試。

USER-FRIENDLY MEASURING CELL: The measuring cell can be easily removed and placed on an analytical balance for weighing viscous samples that are solid at ambient temperature. Water jacketed measuring cells are also available as an option for sub-ambient temperature.
為便于稱量常溫固態試樣,測定容器分為固定的上部和可脫卸的下部兩部分組成，可將下部容器卸下采樣和稱量，十分方便。樣品杯上的環繞水浴設計，可外接加熱/制冷源，保持樣品的溫度特性。

EASY OPERATION: Just sample the specimen and aniline, enter the expected aniline point，and press the START key; all the rest of the test procedures such as heating, cooling and aniline point detection are performed automatically. The operator has an option to report the result after either single determination or multiple determinations.
操作簡單：只要加樣和設定預期苯胺點后,按下“START”鍵，儀器就能自動進行樣品加熱，樣品冷卻，測試苯胺點，連續多次重復試驗等一系列動作。試驗人員只需要直接讀出zui終試驗結果就可以了。
 

EASIER AND SAFER ANILINE HANDLING: For years, handling of the toxic aniline has been considered a hazardous operation. A bottle top dispenser can be connected to the measuring cell for directly delivering aniline without a manual pipetting operation. Upon completing a test, discharge the aniline mixture from the bottom of the measuring cell, pour a cleaning agent, turn on the stirrer, and discharge the cleaning agent. The measuring cell can be cleaned without disassembling it, which makes the cleaning easier and safer.
儀器配合自動進樣器（用戶自配）配合使用。用自動進樣器來處理苯胺，可避免直接處理有毒的化學品苯胺對人體造成傷害。測試完成，可以直接用放液閥直接排出廢液，另行處理。而排出廢液后的樣品杯清洗也很方便，并不需要取下樣品杯手工清洗。配合洗液和儀器本身的加熱功能，即便是重油等不易清洗的試樣也能方便有效地清洗干凈。

DATA HANDLING: The unit is equipped to store up to 20 successive test results and export to an optional printer or to a LIMS through an RS232 port. 記錄儲存zui后20次試驗結果，可外接打印機輸出或通過RS232與自動聯用分析系統連接，聯網操作。

COMPACT DESIGN: Like the popular Tanaka flash point testers, AAP-5 consists of a test head unit and a separate control unit. The test head unit is small enough to be remoy operated inside of a fume hood. 同“田中科學機器制作株式會社”的閃點測試系列儀器一樣，AAP-5可分為“測定部”和“控制部”2個部分，可以上下疊置，占用面積很少，也便于搬動。

SAMPLES:
Transparent or opaque/dark （<8.0 on ASTM color scale）
測試范圍廣。同時適用于透明和不透明（深色/黑色）的樣品。（要求ASTM色小于8.0）

MEASURING RANGE: （測量范圍）
Ambient to 170℃ （338℉） For sub-ambient, use the optional water jacketed measuring cell and a cryostat.
室溫-170℃ （338℉），也可配合的“低溫測試杯”和外接冷源進行低溫苯胺點的測量

TEMPERATURE SENSOR: （溫度傳感器）
PT-100 in stainless steel sheath 帶不繡鋼護套的PT-100鉑電阻

ANILINE POINT DETECTOR: （苯胺點檢測）
Photo-electric cell, with special detection circuitry MEASURING CELL: Modified U-Tube type. Vacuum jacketed glass cell with TFE stopcock at the bottom for drainage.
配合特制的分離式“U”字樣品杯（真空護套,帶排樣閥）取樣、稱量、檢測兼用，光電檢測。

DISPLAY: （顯示）
Vacuum fluorescent display（VFD） 熒光顯示屏（VFD）

HEATER: （加熱）
Immersion heater in stainless steel sheath: 20W 浸沒式不繡鋼加熱器，20W

SEQUENSE CONTROL: 程序控制
By an on-board microcomputer 內置微處理器

TEST MODE:
Single or repeated determinations （2 kinds, average is reported to nearest 0.05℃）

DATA OUTPUT: （數據輸出）
RS-232C  1 channel  （for PC or Optional Printer） RS-232C 接口，1，可連接電腦或打印機

SAFETY MECHANISM: （安全保護）
Automatically shuts off and the problem is reported by buzzer and display, in case:
在下列情況下，儀器自動停止試驗，連續報警并顯示出錯信息：

（a） EAP+10℃ or at 170℃ is reached, 超過預期苯胺點10℃時,或到170℃還沒測出苯胺點時,
（b） Temperature sensor is found defective, 溫度傳感器失效時
（c） Light projector or receiver is found defective光電檢測組件失效時
（d） Control computer runs away （no display） 微處理器出錯（無顯示）

DIMENSION & WEIGHT: （體積/重量）
控制部Control unit: 230W x 455D x 105H （mm）, 7.0kg
測試部Test unit: 230W x 350D x 580H （mm）, 8.0kg

INSTALLATION SITE: 環境要求
Ambient temperature: 0 to 40℃ RH: Less than 90%（no condensation）
室溫0～40℃/ 濕度90%以下（無凝結）

POWER SUPPLY: （電源要求）
AC100/120V or 220/240V 50/60Hz （set at the factory）出廠設定，定購前要說明
0.1kW（max.）  zui大功率0.1kW

ORDERING INFORMATION: 
STANDARD ACCESSORIES: （標準附件）
 

OPIONAL ACCESSORIES: （選購件1）
Water Jacketed Measuring Cell, Lower低溫測試樣品杯，低溫測試
Power Connecting Cable, 3m加長電源連接線
Signal Connecting Cable, 3m 加長數據連接線
Built-in Clock Board （for time/date verification） 時鐘板（提供日期/時間）
Printer, BS2-80TS 打印機  （*配合時鐘板使用，可直接打印日期/時間）
（we recommend that optional Built-in Clock Board be purchased with this Printer）

SUGGESTED SPARES FOR 2 YEARS: （選購件2，2年維護）

TFE tubing connected to measuring cell for direct connection to bottle-top dispenser for a safer aniline handling. TFE tubing and fitting not provided with AAP-5.

 

我們*選用（2口型的樣品杯上部組件）和自動進樣器（用戶自配）配合使用。用自動進樣器來處理苯胺，可避免直接處理有毒的化學品苯胺對人體造成傷害。
（2口型的樣品杯上部組件）和四氟乙烯（TFE）連接套件在選購件中都有提供。